This is a 3D Printed snug fitting case for the Arduino Mega 2560 with screw board mounts and a snap top. Shields may be installed over the top of the case. There are four holes on the top to view the four LEDs on the Arduino board. These holes can accommodate Bivar PLP2-250 light pipes for a more polished look.

The screws for the Arduino board are #2 x 1/4″ thread rolling screws.

Features:

• Opening for GPIO Pins
• Shields can be mounted on top
• Compact Design
• Perfect Fit
• Can be used as a protective case

Additional Information